A life management approach on in-service device in refining unit was presented in this paper. By means of this method, corporate resources can reasonably be allocated. And a long-term operation of the equipment can be ensured. First, according to the type of the equipments, statistical analysis of equipments was carried out to obtain the life stages: early life stage, middle life stage, late life stage, extended life stage. Then, based on damage mechanism residual life of the equipments was calculated out. At the same time, the recommended maintenance cycle was given. If the operational life of the equipments cannot meet the expected life, the cause analysis should be done. The subsequent processing steps, such as maintenance, repair and renewal were proposed. Next, the equipments in the corporation were classified. For different class of the equipments, the different management methods were given. Finally, a re-evaluation of life was conducted.
Skip Nav Destination
ASME 2014 Pressure Vessels and Piping Conference
July 20–24, 2014
Anaheim, California, USA
Conference Sponsors:
- Pressure Vessels and Piping Division
ISBN:
978-0-7918-4598-1
PROCEEDINGS PAPER
A Life Management Method on In-Service Equipment in Refining Unit
Hui Wang,
Hui Wang
China Special Equipment Inspection and Research Institute, Beijing, China
Search for other works by this author on:
Guodong Jia,
Guodong Jia
China Special Equipment Inspection and Research Institute, Beijing, China
Search for other works by this author on:
Xiang Li,
Xiang Li
China Special Equipment Inspection and Research Institute, Beijing, China
Search for other works by this author on:
Guoshan Xie,
Guoshan Xie
China Special Equipment Inspection and Research Institute, Beijing, China
Search for other works by this author on:
Weihua Wang
Weihua Wang
China Special Equipment Inspection and Research Institute, Beijing, China
Search for other works by this author on:
Hui Wang
China Special Equipment Inspection and Research Institute, Beijing, China
Guodong Jia
China Special Equipment Inspection and Research Institute, Beijing, China
Xiang Li
China Special Equipment Inspection and Research Institute, Beijing, China
Guoshan Xie
China Special Equipment Inspection and Research Institute, Beijing, China
Weihua Wang
China Special Equipment Inspection and Research Institute, Beijing, China
Paper No:
PVP2014-29045, V001T01A087; 5 pages
Published Online:
November 18, 2014
Citation
Wang, H, Jia, G, Li, X, Xie, G, & Wang, W. "A Life Management Method on In-Service Equipment in Refining Unit." Proceedings of the ASME 2014 Pressure Vessels and Piping Conference. Volume 1: Codes and Standards. Anaheim, California, USA. July 20–24, 2014. V001T01A087. ASME. https://doi.org/10.1115/PVP2014-29045
Download citation file:
12
Views
0
Citations
Related Proceedings Papers
Related Articles
Air Gap Response of Floating Structures: Statistical Predictions Versus Observed Behavior
J. Offshore Mech. Arct. Eng (August,2001)
Correlation of Support Impact Force and Fretting-Wear for a Heat Exchanger Tube
J. Pressure Vessel Technol (February,1984)
Energy-Oriented Maintenance Decision-Making for Sustainable Manufacturing Based on Energy Saving Window
J. Manuf. Sci. Eng (May,2018)
Related Chapters
Defect Assessment
Pipeline Integrity Assurance: A Practical Approach
Introduction
Computer Vision for Structural Dynamics and Health Monitoring
Reasons for Lay-Up
Consensus for the Lay-up of Boilers, Turbines, Turbine Condensors, and Auxiliary Equipment (CRTD-66)