The biologically inspired Sprawl family of hexapedal robots has shown that fast and stable running is possible with only open-loop control. Proper design of the passively self-stabilizing leg structure has enabled these robots to run at speeds of up to 15 bodylengths/s and over uneven terrain. Unlike other running robots built to date, the Sprawl robots’ front and rear legs are designed to preform distinct functional roles. Like the cockroaches that inspired them, the front legs of the robots act to lift and decelerate, while the rear legs provide the primary forward thrust. This paper uses a dynamic simulation to investigate the effect that changing the robot’s leg structure and posture has on its performance. The simulation results support our hypothesis that the use of a differential leg function induced through postural adjustments effectively trades efficiency for stability.
Skip Nav Destination
e-mail: jonclark@seas.upenn.edu
Article navigation
March 2006
Technical Papers
The Effect of Leg Specialization in a Biomimetic Hexapedal Running Robot
Jonathan E. Clark,
Jonathan E. Clark
Department of ESE,
e-mail: jonclark@seas.upenn.edu
University of Pennsylvania
, Philadelphia, PA 19104
Search for other works by this author on:
Mark R. Cutkosky
Mark R. Cutkosky
Department of Mechanical Engineering,
Stanford University
, Stanford, CA 94305
Search for other works by this author on:
Jonathan E. Clark
Department of ESE,
University of Pennsylvania
, Philadelphia, PA 19104e-mail: jonclark@seas.upenn.edu
Mark R. Cutkosky
Department of Mechanical Engineering,
Stanford University
, Stanford, CA 94305J. Dyn. Sys., Meas., Control. Mar 2006, 128(1): 26-35 (10 pages)
Published Online: December 1, 2005
Article history
Received:
April 1, 2005
Revised:
December 1, 2005
Citation
Clark, J. E., and Cutkosky, M. R. (December 1, 2005). "The Effect of Leg Specialization in a Biomimetic Hexapedal Running Robot." ASME. J. Dyn. Sys., Meas., Control. March 2006; 128(1): 26–35. https://doi.org/10.1115/1.2168477
Download citation file:
Get Email Alerts
An Adaptive Sliding-Mode Observer-Based Fuzzy PI Control Method for Temperature Control of Laser Soldering Process
J. Dyn. Sys., Meas., Control
Fault detection of automotive engine system based on Canonical Variate Analysis combined with Bhattacharyya Distance
J. Dyn. Sys., Meas., Control
Multi Combustor Turbine Engine Acceleration Process Control Law Design
J. Dyn. Sys., Meas., Control (July 2025)
Related Articles
An Approach to Identify Joint Motions for Dynamically Stable Walking
J. Mech. Des (May,2006)
Search for Initial Conditions for Sustained Hopping of Passive Springy-Leg Offset-Mass Hopping Robot
J. Dyn. Sys., Meas., Control (July,2007)
Introduction of the Foot Placement Estimator: A Dynamic Measure of Balance for Bipedal Robotics
J. Comput. Nonlinear Dynam (January,2008)
On the Stability of Robot Compliant Motion Control: Theory and Experiments
J. Dyn. Sys., Meas., Control (September,1990)
Related Proceedings Papers
Related Chapters
Dynamic Control Strategy of a Biped Inspired from Human Walking
Intelligent Engineering Systems through Artificial Neural Networks Volume 18
QP Based Encoder Feedback Control
Robot Manipulator Redundancy Resolution
Accommodation and Stability of Alloying Elements in Amorphous Grain Boundaries of Zirconia
Zirconium in the Nuclear Industry: 20th International Symposium