This paper studies tubular buckling in curved wellbores (such as the build section of horizontal wells) and its effect on tubular “lockup” in horizontal or extended-reach wells. New buckling load equations are derived to properly predict tubular sinusoidal and helical buckling in such wellbores. The results show that the buckling loads to initiate sinusoidal and helical buckling of tubulars in curved wellbores are usually much larger than those in straight wellbores. This is because the curved wellbore tends to hold the axially compressed tubular against the outer-curve side of the wellbore. The tubular becomes less easy to buckle until higher axial compressive loads are applied. Less tubular lockup risk is then predicted for tubulars in horizontal or extended-reach wells by using the new buckling load equations. The new buckling loads in curved wellbores agree with those in straight wellbores when wellbore curvature approaches zero. Small-scale laboratory experiments also confirmed these theoretically derived buckling loads.

Chen, Y. C., Lin, Y. H., and Cheatham, J. B., 1990, “Tubing and Casing Buckling in Horizontal Wells,” JPT, Feb., pp. 140–141, 191.
Dawson, R., and Paslay, P. R., 1984, “Drillpipe Buckling in Inclined Holes,” JPT, Oct., pp. 1734–1738.
He, X., and Kyllingstad, A., 1993, “Helical Buckling and Lock-up Conditions for Coiled Tubing in Curved Wells,” paper No. SPE 25370 presented at the SPE Asia Pacific Oil and Gas Conference and Exhibition, Singapore, February, 8–11.
Lubinski, A., Althouse, W. S., and Logan, J. L., 1962, “Helical Buckling of Tubing Sealed in Packers,” JPT, June, pp. 655–670.
Mitchell, R. F., 1986, “Simple Frictional Analysis of Helical Buckling of Tubing,” SPE Drilling Engineering, Dec., pp. 457–465.
Schuh, F. J., 1991, “The Critical Buckling Force and Stresses for Pipe in Inclined Curved Boreholes,” Paper No. SPE/IADC 21942 presented at the SPE/IADC Drilling Conference, Amsterdam, The Netherlands, March 11–14.
Wu, J., 1992, “Buckling Behavior of Pipes in Directional and Horizontal Wells,” Ph.D. dissertation, Texas A&M University.
Wu, J., and Juvkam-Wold, H. C., 1994, “Buckling and Lockup of Tubulars in Inclined Wellbores,” presented at the ETCE Drilling Technology Symposium, New Orleans, LA, January 23–26.
This content is only available via PDF.
You do not currently have access to this content.