The incompressible turbulent flow over a backward-facing step in a rectangular duct was investigated experimentally. The side wall effects on the core flow were determined by varying the aspect ratio (defined as the step span-to-height ratio) from 1 to 28. The Reynolds number, based on the step height and the oncoming free-stream velocity, was 26,500. Detailed velocity measurements were made, including the turbulent stresses, in a region which extended past the flow reattachment zone. Wall static pressure was also measured on both the step and flat walls. In addition, surface visualizations were obtained on all four walls surrounding the separated flow to supplement near-wall velocity measurements. The results show that the aspect ratio has an influence on both the velocity and wall pressure even for relatively large aspect ratios. For example, in the redevelopment region downstream of reattachment, the recovery pressure decreases with smaller aspect ratios. The three-dimensional side wall effects tend to slow down the relaxation downstream of reattachment for smaller aspect ratios as evidenced by the evolution of the velocity field. For the two smallest aspect ratios investigated, higher centerplane streamwise and transverse velocities were obtained which indicate a three-dimensional mean flow structure along the full span of the duct.
Skip Nav Destination
Article navigation
March 1995
Research Papers
Separating and Reattaching Flow Structure in a Suddenly Expanding Rectangular Duct
G. Papadopoulos,
G. Papadopoulos
Turbulent Fluid Mechanics Laboratory, Polytechnic University, Brooklyn, NY 11201
Search for other works by this author on:
M. V. O¨tu¨gen
M. V. O¨tu¨gen
Turbulent Fluid Mechanics Laboratory, Polytechnic University, Brooklyn, NY 11201
Search for other works by this author on:
G. Papadopoulos
Turbulent Fluid Mechanics Laboratory, Polytechnic University, Brooklyn, NY 11201
M. V. O¨tu¨gen
Turbulent Fluid Mechanics Laboratory, Polytechnic University, Brooklyn, NY 11201
J. Fluids Eng. Mar 1995, 117(1): 17-23 (7 pages)
Published Online: March 1, 1995
Article history
Received:
March 21, 1994
Revised:
October 27, 1994
Online:
December 4, 2007
Citation
Papadopoulos, G., and O¨tu¨gen, M. V. (March 1, 1995). "Separating and Reattaching Flow Structure in a Suddenly Expanding Rectangular Duct." ASME. J. Fluids Eng. March 1995; 117(1): 17–23. https://doi.org/10.1115/1.2816809
Download citation file:
Get Email Alerts
A Study of the Velocity Field During Mitigation of Vortex Breakdown in Model Francis Turbine at High Load
J. Fluids Eng (April 2023)
Numerical Studies of Bubbles in Swirling Channel Flows
J. Fluids Eng (April 2023)
Related Articles
Near Wall Measurements for a Turbulent Impinging Slot Jet (Data Bank Contribution
J. Fluids Eng (March,2001)
Curved Ducts With Strong Secondary Motion: Velocity Measurements of Developing Laminar and Turbulent Flow
J. Fluids Eng (September,1982)
Characteristics of Shallow Turbulent Near Wakes at Low Reynolds Numbers
J. Fluids Eng (June,2000)
Slot Jet Impinging On A Concave Curved Wall
J. Fluids Eng (May,2005)
Related Chapters
Cavitating Structures at Inception in Turbulent Shear Flow
Proceedings of the 10th International Symposium on Cavitation (CAV2018)
Experimental Investigation of Ventilated Supercavitation Under Unsteady Conditions
Proceedings of the 10th International Symposium on Cavitation (CAV2018)
Global Mode Visualization in Cavitating Flows
Proceedings of the 10th International Symposium on Cavitation (CAV2018)