This study has identified useful reduced kinetic schemes that can be used in comprehensive multidimensional gas-turbine combustor models. Reduced mechanisms lessen computational cost and possess the capability to accurately predict the overall flame structure, including gas temperatures and key intermediate species such as CH4, CO, and NOx. In this study, four new global mechanisms with five, six, seven, and nine steps based on the full GRI 2.11 mechanism, were developed and evaluated for their potential to model natural gas chemistry (including NOx chemistry) in gas turbine combustors. These new reduced mechanisms were optimized to model the high pressure and fuel-lean conditions found in gas turbines operating in the lean premixed mode. Based on perfectly stirred reactor (PSR) and premixed code calculations, the five-step reduced mechanism was identified as a promising model that can be used in a multidimensional gas-turbine code for modeling lean-premixed, high-pressure turbulent combustion of natural gas. Predictions of temperature, CO, CH4, and NO from the five-to nine-step reduced mechanisms agree within 5 percent of the predictions from the full kinetic model for 1 < pressure (atm) < 30, and 0.6 < φ < 1.0. If computational costs due to additional global steps are not severe, the newly developed nine step global mechanism, which is a little more accurate and provided the least convergence problems, can be used. Future experimental research in gas turbine combustion will provide more accurate data, which will allow the formulation of better full and reduced mechanisms. Also, improvement in computational approaches and capabilities will allow the use of reduced mechanisms with larger global steps, perhaps full mechanisms.

Issue Section:
Gas Turbines: Combustion and Fuels
Topics:
Combustion, Methane, Modeling, Natural gas, Nitrogen oxides, Turbulence, Gas turbines, Chemistry, Combustion chambers, High pressure (Physics), Temperature, Flames, Fuels, Pressure
1.
Anand
M. S.
, and
Gouldin
F. C.
,
1985
, “
Combustion Efficiency of a Premixed Continuous Flow Combustor
,”
ASME JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER
, Vol.
107
, pp.
695
–
705
.
2.
Bilger
R. W.
,
Sta˚rner
S. H.
, and
Kee
R. J.
,
1990
, “
On Reduced Mechanisms for Methane-Air Combustion in Nonpremixed Flames
,”
Combustion and Flame
, Vol.
80
, pp.
135
–
149
.
3.
Borghi
R.
,
1988
, “
Turbulent Combustion Modelling
,”
Progress in Energy and Combustion Science
, Vol.
14
, pp.
245
–
292
.
4.
Bowman, C. T., Hanson, R. K., Gardiner, W. C., Lissianski, V., Frenklach, M., Goldenberg, M., Smith, G. P., Crosley, D. R., Golden, D. M., 1995, GRI Mech 2.11, 1995, http://www.gri.org.
5.
Cannon, S. M., Brewster, B. S., and Smoot, L. D., 1996, “Prediction of CO and NOx, in Lean Premixed Turbulent Combustion,” presented at the Fall 1996 Meeting of the Western States Section/Combustion Institute, University of Southern California, Los Angeles, CA.
6.
Cannon, S. M., 1997, “Modeling of Lean Premixed Gaseous Turbulent Combustion,” Ph. D. dissertation, Mechanical Engineering Department, Brigham Young University, Provo, UT.
7.
Cannon
S. M.
,
Brewster
B. S.
, and
Smoot
L. D.
,
1998
, “
Stochastic Modeling of CO and NO in Premixed Methane Combustion
,”
Combustion and Flame
, Vol.
113
, pp.
137
–
146
.
8.
Chen
J. Y.
,
1988
, “
A General Procedure for Constructing Reduced Reaction Mechanisms with Given Independent Reactions
,”
Combustion Science and Technology
, Vol.
57
, pp.
89
–
94
.
9.
Chang, W. C., 1995, “Modeling of NOx, Formation in Turbulent Flames—Development of Reduced Mechanisms and Mixing Models,” Ph. D. thesis, University of California at Berkeley.
10.
Correa
S. M.
,
1992
a, “
Carbon Monoxide Emissions in Lean Premixed Combustion
,”
Journal of Propulsion and Power
, Vol.
8
, pp.
1144
–
1151
.
11.
Correa
S. M.
,
1992
b, “
A Review of NOx Formation Under Gas-Turbine Combustion Conditions
,”
Combustion Science and Technology
, Vol.
87
, pp.
329
–
362
.
12.
Davis, L. B., and Washam, R. M., 1989, “Development of a Dry Low NOx Combustor,” presented at the Gas Turbine and Aeroengine Congress and Exposition, June 4–8, Toronto, Canada.
13.
Glarborg, P., Kee, R. J., Grear, J. F., and Miller, J. A., 1992a, “PSR: A Fortran Program for Modeling Well-Stirred Reactors,” report, SAND86-8209. UC-4, Sandia National Laboratories. Livermore, CA.
14.
Glarborg, P., Lilleheie, N. I., Byggstoyl, S., Magnu¨ssen, B. F., Kilpinen, P., and Hupa, M., 1992b, “A Reduced Mechanism for Nitrogen Chemistry in Methane Combustion,” Twenty-Fourth Symposium (International) on Combustion, The Combustion Institute, Pittsburgh, PA, pp. 889–898.
15.
Kee, R. J., Grear, J. F., Smooke, M. D., and Miller, J. A., 1992a, “A Fortran Program for Modeling Steady Laminar One-Dimensional Premixed Flames,” report, SAND85-8240. UC-401, Sandia National Laboratories, New Mexico.
16.
Kee, R. J., Rupley, F. M., and Miller, J. A., 1992b, “Chemkin-II: A Fortran Chemical Kinetics Package for the Analysis of Gas-Phase Chemical Kinetics,” report, SAND89-8009B. UC706, Sandia National Laboratories, New Mexico.
17.
Maas, U., and Pope, S. B., 1992a, “Implementation of Simplified Chemical Kinetics Based on Intrinsic Low-Dimensional Manifolds,” Twenty-Fourth Symposium (International) on Combustion, The Combustion Institute, Pittsburgh, PA, pp. 103–112.
18.
Maas
U.
, and
Pope
S. B.
,
1992
b, “
Simplifying Chemical Kinetics: Intrinsic Low-Dimensional Manifolds in Composition Space
,”
Combustion and Flame
, Vol.
88
, pp.
239
–
264
.
19.
Mallampalli, H., 1996, “Evaluation of Global CH4/NOx Mechanisms for Modeling Lean Premixed Turbulent Combustion of Natural Gas,” M.S. thesis, Brigham Young University, Provo, UT.
20.
Mallampalli, H., Fletcher, T. H., Chen, J. Y., 1996, “Evaluation of Global CH4/NOx Mechanisms for Modeling Lean Premixed Turbulent Combustion of Natural Gas,” Paper 96F-098, Western States Section of the Combustion Institute, University of Southern California, Los Angeles, CA; see also: http://www.et.byu.edu/˜tom/Papers/Hemant-WSS96/WSS.html
21.
Miller
J. A.
, and
Bowman
C. T.
,
1989
, “
Mechanism and Modeling of Nitrogen Chemistry in Combustion
,”
Progress in Energy and Combustion Science
, Vol.
15
, pp.
287
–
338
.
22.
Nicol, D. G., Steele, R. C, Marinov, N. M., and Malte, P. C, 1993, “The Importance of Nitrous Oxide Pathway to NOx in Lean Premixed Combustion,” Presented at the ASME International Gas Turbine and Aeroengine Congress and Exposition, Cincinnati, Ohio.
23.
Nicol, D. G., Malte, P. C, Hamer, A., Roby, R. J., and Steele, R. C, 1997, “A Five-Step Global Mechanism for Methane Oxidation with NO Formation for Lean-Premixed Combustion: Development of the Mechanism and Application to a Gas Turbine Combustor,” Presented at the Western States Section of the Combustion Institute. April 14–15, Paper 97s-039, Livermore, CA.
24.
Nicol, D. G., Malte, P. C., Hamer, A., Roby, R. J., and Steele, R. C. 1998, “Development of a Five-Step Global Methane Oxidation—NO Formation Mechanism for Lean-Premixed Gas Turbine Combustion,” accepted for the ASME International Gas Turbine and Aeroengine Congress, Stokholm, Sweden.
25.
Polifke, W., Dobbeling, K., Sattlemayer, T., Nicol, D. G., and Malte, P. C. 1995, “A NOx Prediction Scheme for Lean Premixed Gas Turbine Combustion based on Detailed Chemical Kinetics,” International Gas Turbine and Aeroengine Congress and Exposition, ASME, New York, NY.
26.
Smooke, M. D., and Giovangigli, V., 1991, “Formulation of the Premixed and Nonpremixed Test Problems,” Reduced Chemical Mechanisms and Asymptotic Approximations for Methane-Air Flames, M. D. Smooke, ed., Springer-Verlag, New York, pp. 1–28.
27.
Steele
R. C.
,
Matle
P. C.
,
Nicol
D. G.
, and
Kramlich
J. C.
,
1994
, “
NOx and N2O in Lean Premixed Jet-Stirred Flames
,”
Combustion and Flame
, Vol.
100
, No.
3
pp.
440
–
449
.
28.
Trevin˜o, C, and Mende´z, F., 1992, “Reduced Kinetic Mechanisum for Methane Ignition,” Twenty-Fourth Symposium (International) on Combustion, The Combustion Institute, Pittsburgh, PA, pp. 121–12.
29.
Wang
H.
, and
Frenklach
M.
,
1991
, “
Detailed Reduction of Reaction Mechanisms for Flame Modeling
,”
Combustion and Flame
, Vol.
87
, pp.
365
–
370
.
This content is only available via PDF.
Copyright © 1998
 by The American Society of Mechanical Engineers
You do not currently have access to this content.