The objective of the paper is to assess the feasibility of the neural network (NN) approach in power plant process evaluations. A “feed-forward” technique with a back propagation algorithm was applied to a gas turbine equipped with waste heat boiler and water heater. Data from physical or empirical simulators of plant components were used to train such a NN model. Results obtained using a conventional computing technique are compared with those of the direct method based on a NN approach. The NN simulator was able to perform calculations in a really short computing time with a high degree of accuracy, predicting various steady-state operating conditions on the basis of inputs that can be easily obtained with existing plant instrumentation. The optimization of NN parameters like number of hidden neurons, training sample size, and learning rate is discussed in the paper.

Issue Section:
Gas Turbines: Environmental and Regulatory Affairs
Keywords:
neural nets, simulation, gas turbines, heat, industrial plants
Topics:
Artificial neural networks, Gas turbines, Optimization, Heat recovery
1.
Parrella, M., Frangopoulos, C. A., Pitt, R. U., Cerri, G., Williams, B. C., Vignolini, M., Psychogios, J., and Salvador, S., 1999, “Optimum Management System with Environment Monitoring,” OMSEM Publishable Report, The European Commission Non Nuclear Energy Program, JOULE III.
2.
Cerri, G., Monacchia, S., and Seyedan, B., 1999, “Optimum Load Allocation in Cogeneration Gas-Steam Combined Plants,” ASME paper 99-GT-6, International Gas Turbine and Aero Engine Congress and Exhibition, Indianapolis, June 7–10, 1999.
3.
Cerri, G., 1996, “A Simultaneous Solution Method Based on A Modular Approach for Power Plant Analyses and Optimized Designs and Operations,” International Gas Turbine and Aeroengine Congress and Exhibition, Birmingham, UK, June 10–13, 1996.
4.
Bohn, D., Dibellius, G. H., Pitt, R. U., Faatz, R., Cerri, G., and Salvini, C., 1992, “Study on Pressurized Fluidized Bed Combustion Combined Cycles with Gas Turbine Topping Cycle,” ASME paper 92-GT-343.
5.
Bohn, D., Dibellius, G. H., Pitt, R. U., Faatz, R., Cerri, G., and Salvini, C., 1993, “Optimizing a Pressurized Fluidized Bed Combustion Combined Cycles with Gas Turbine Topping Cycle,” ASME paper 93-GT-390.
6.
Cerri, G., 1982, “Parametric Analysis of Combined Gas-Steam Cycles,” American Society of Mechanical Engineers, Gas Turbine Division of the ASME, New York, Paper 82-GT-95.
7.
Cerri
,
G.
,
Sorrenti
,
A.
, and
Zhang
,
Q.
,
1997
, “
Optimization of Cleaning Timing and Load Allocation in Steam Generator Management
,”
Appl. Therm. Eng.
,
18
, Nos.
3–4
, pp.
111
–
120
.
8.
Hopfield
,
J. J.
, and
Tank
,
D. W.
,
1986
, “
Computing With Neural Circuits: A Model Properties Like Those of Two State Neurons
,”
Science
,
233
, pp.
625
–
633
.
9.
Rumelhart, D. E., McClelland, J. L., and the PDP Research Group, 1987, “Parallel Distributed Processing: Explorations in the Microstructure of Cognition,” MIT Press, Cambridge, MA.
10.
Sejnowski, T., and Rosenberg, C. R., 1986, “NETtalk: A Parallel Network That Learns to Read Aloud,” Technical Report No. JHU/EECS- 86/01, John Hopkins University, Baltimore, MD.
11.
Boccaletti, C., Cerri, G., Khatri, D. S., and Seyedan, B., 1999, “An Application Of Neural Network In Combustion Processes Evaluations,” in Proceedings of International Conference on Enhancement and Promotion of Computational Methods in Engineering and Science (EPMESC VII), Macao, August 2–5, 1999.
12.
Boccaletti, C., Cerri, G., Khatri, D. S., and Seyedan, B., 1999, “Neural Network Approach in Gas Expansion Evaluations,” in Fourteenth International Symposium on Airbreathing Engines (ISABE), Florence, Italy, September 5–10, 1999.
Copyright © 2001
 by ASME
You do not currently have access to this content.