Biomass can be converted to energy via direct combustion or thermochemical conversion to liquid or gas fuels. This study focuses on burning producer gases derived from gasifying biomass wastes to produce power. Since the producer gases are usually of low calorific values (LCV), power plant performance under various operating conditions has not yet been proven. In this study, system performance calculations are conducted for power plants. The power plants considered include simple gas turbine systems, steam turbine systems, combined cycle systems, and steam injection gas turbine systems using the producer gas with low calorific values at approximately 30% and 15% of the natural gas heating value (on a mass basis). The LCV fuels are shown to impose high compressor back pressure and produce increased power output due to increased fuel flow. Turbine nozzle throat area is adjusted to accommodate additional fuel flows to allow the compressor to operate within safety margin. The best performance occurs when the designed pressure ratio is maintained by widening nozzle openings, even though the turbine inlet pressure is reduced under this adjustment. Power augmentations under four different ambient conditions are calculated by employing gas turbine inlet fog cooling. Comparison between inlet fog cooling and steam injection using the same amount of water mass flow indicates that steam injection is less effective than inlet fog cooling in augmenting power output. Maximizing steam injection, at the expense of supplying the steam to the steam turbine, significantly reduces both the efficiency and the output power of the combined cycle. This study indicates that the performance of gas turbine and combined cycle systems fueled by the LCV fuels could be very different from the familiar behavior of natural gas fired systems. Care must be taken if on-shelf gas turbines are modified to burn LCV fuels.
Skip Nav Destination
Article navigation
July 2007
Technical Papers
Simulation of Producer Gas Fired Power Plants with Inlet Fog Cooling and Steam Injection
Mun Roy Yap,
Mun Roy Yap
Energy Conversion and Conservation Center,
University of New Orleans
, New Orleans, LA 70148-2220
Search for other works by this author on:
Ting Wang
Ting Wang
Energy Conversion and Conservation Center,
University of New Orleans
, New Orleans, LA 70148-2220
Search for other works by this author on:
Mun Roy Yap
Energy Conversion and Conservation Center,
University of New Orleans
, New Orleans, LA 70148-2220
Ting Wang
Energy Conversion and Conservation Center,
University of New Orleans
, New Orleans, LA 70148-2220J. Eng. Gas Turbines Power. Jul 2007, 129(3): 637-647 (11 pages)
Published Online: December 9, 2006
Article history
Received:
October 23, 2006
Revised:
December 9, 2006
Citation
Roy Yap, M., and Wang, T. (December 9, 2006). "Simulation of Producer Gas Fired Power Plants with Inlet Fog Cooling and Steam Injection." ASME. J. Eng. Gas Turbines Power. July 2007; 129(3): 637–647. https://doi.org/10.1115/1.2718571
Download citation file:
Get Email Alerts
Cited By
On Leakage Flows In A Liquid Hydrogen Multi-Stage Pump for Aircraft Engine Applications
J. Eng. Gas Turbines Power
A Computational Study of Temperature Driven Low Engine Order Forced Response In High Pressure Turbines
J. Eng. Gas Turbines Power
The Role of the Working Fluid and Non-Ideal Thermodynamic Effects on Performance of Gas Lubricated Bearings
J. Eng. Gas Turbines Power
Tool wear prediction in broaching based on tool geometry
J. Eng. Gas Turbines Power
Related Articles
System Study on Partial Gasification Combined Cycle With C O 2 Recovery
J. Eng. Gas Turbines Power (September,2008)
Degradation Effects on Combined Cycle Power Plant Performance—Part III: Gas and Steam Turbine Component Degradation Effects
J. Eng. Gas Turbines Power (April,2004)
Application of “H Gas Turbine” Design Technology to Increase Thermal Efficiency and Output Capability of the Mitsubishi M701G2 Gas Turbine
J. Eng. Gas Turbines Power (April,2005)
Analysis of Gas-Steam Combined Cycles With Natural Gas Reforming and CO 2 Capture
J. Eng. Gas Turbines Power (July,2005)
Related Proceedings Papers
Related Chapters
Combined Cycle Power Plant
Energy and Power Generation Handbook: Established and Emerging Technologies
Introduction
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration
Performance Testing of Combined Cycle Power Plant
Handbook for Cogeneration and Combined Cycle Power Plants, Second Edition