Mean-velocity-field and turbulence data are presented that measure turbulent flow phenomena in an approximately 1:7 scale model of a region of the lower plenum of a typical prismatic gas-cooled reactor similar to a General Atomics gas-turbine-modular helium reactor design. The data were obtained in the Matched-Index-of-Refraction (MIR) Facility at Idaho National Laboratory (INL) and are offered for assessing computational fluid dynamics software. This experiment has been selected as the first standard problem endorsed by the Generation IV International Forum. Results concentrate on the region of the lower plenum near its far reflector wall (away from the outlet duct). The flow in the lower plenum consists of multiple jets injected into a confined cross flow—with obstructions. The model consists of a row of full circular posts along its centerline with half-posts on the two parallel walls to approximate geometry scaled to that expected from the staggered parallel rows of posts in the reactor design. The model is fabricated from clear, fused quartz to match the refractive-index of the working fluid so that optical techniques may be employed for the measurements. The benefit of the MIR technique is that it permits optical measurements to determine flow characteristics in complex passages in and around objects to be obtained without locating intrusive transducers that will disturb the flow field and without distortion of the optical paths. An advantage of the INL system is its large size, leading to improved spatial and temporal resolutions compared with similar facilities at smaller scales. A three-dimensional particle image velocimetry system was used to collect the data. Inlet-jet Reynolds numbers (based on the jet diameter and the time-mean bulk velocity) are approximately 4300 and 12,400. Uncertainty analyses and a discussion of the standard problem are included. The measurements reveal developing, nonuniform, turbulent flow in the inlet jets and complicated flow patterns in the model lower plenum. Data include three-dimensional vector plots, data displays along the coordinate planes (slices), and presentations that describe the component flows at specific regions in the model. Information on inlet conditions is also presented.
Skip Nav Destination
Article navigation
February 2010
Research Papers
Measurement of Flow Phenomena in a Lower Plenum Model of a Prismatic Gas-Cooled Reactor
Donald M. McEligot,
Donald M. McEligot
Professor Emeritus
University of Arizona
, Tucson, AZ 85721; Idaho National Laboratory
, P.O. Box 1625, Idaho Falls, ID 83415-3870
Search for other works by this author on:
Robert J. Pink
Robert J. Pink
Search for other works by this author on:
Hugh M. McIlroy, Jr.
Donald M. McEligot
Professor Emeritus
University of Arizona
, Tucson, AZ 85721; Idaho National Laboratory
, P.O. Box 1625, Idaho Falls, ID 83415-3870
Robert J. Pink
J. Eng. Gas Turbines Power. Feb 2010, 132(2): 022901 (7 pages)
Published Online: November 2, 2009
Article history
Received:
August 12, 2008
Revised:
August 14, 2008
Online:
November 2, 2009
Published:
November 2, 2009
Citation
McIlroy, H. M., Jr., McEligot, D. M., and Pink, R. J. (November 2, 2009). "Measurement of Flow Phenomena in a Lower Plenum Model of a Prismatic Gas-Cooled Reactor." ASME. J. Eng. Gas Turbines Power. February 2010; 132(2): 022901. https://doi.org/10.1115/1.3078784
Download citation file:
Get Email Alerts
Cited By
Image-based flashback detection in a hydrogen-fired gas turbine using a convolutional autoencoder
J. Eng. Gas Turbines Power
Fuel Thermal Management and Injector Part Design for LPBF Manufacturing
J. Eng. Gas Turbines Power
An investigation of a multi-injector, premix/micromix burner burning pure methane to pure hydrogen
J. Eng. Gas Turbines Power
Related Articles
Secondary Flow Measurements in a Turbine Passage With Endwall Flow Modification
J. Turbomach (October,2000)
Analysis of Turbulent Mixing Jets in a Large Scale Tank
J. Fluids Eng (January,2008)
A Study of Cycle-to-Cycle Variations and the Influence of Charge Motion Control on In-Cylinder Flow in an IC Engine
J. Fluids Eng (May,2010)
Numerical Modeling and Analysis of Entrainment in Turbulent Jets After the End of Injection
J. Fluids Eng (August,2010)
Related Proceedings Papers
Related Chapters
Pulsation and Vibration Analysis of Compression and Pumping Systems
Pipeline Pumping and Compression Systems: A Practical Approach, Second Edition
Pulsation and Vibration Analysis of Compression and Pumping Systems
Pipeline Pumping and Compression System: A Practical Approach, Third Edition
Antilock-Braking System Using Fuzzy Logic
International Conference on Mechanical and Electrical Technology, 3rd, (ICMET-China 2011), Volumes 1–3