Issue Section:
Technical Briefs
1.
Bejan
A.
Sciubba
E.
1992
, “The Optimal Spacing of Parallel Plates Cooled by Forced Convection
,” Int. J. Heat Mass Transfer
, Vol. 35
, pp. 3259
–3264
.2.
Bejan, A., 1993, Heat Transfer, Wiley, New York, p. 328.
3.
Bhattacharjee, S., and Grosshandler, W. L., 1988, “The Formation of a Wall Jet Near a High Temperature Wall Under Microgravity Environment,” ASME HTD-Vol. 96, pp. 711–716.
4.
Jubran
B. A.
Hamdan
M. A.
Abdualh
R. M.
1993
, “Enhanced Heat Transfer, Missing Pin, and Optimization of Cylindrical Pin Fin Arrays
,” ASME JOURNAL OF HEAT TRANSFER
, Vol. 115
, pp. 576
–583
.5.
Knight
R. W.
Goodling
J. S.
Hall
D. J.
1991
, “Optimal Thermal Design of Forced Convection Heat Sinks—Analytical
,” ASME Journal of Electronic Packaging
, Vol. 113
, pp. 313
–321
.6.
Morega
Al. M.
Bejan
A.
Lee
S. W.
1995
, “Free Stream Cooling of a Stack of Parallel Plates
,” Int. J. Heat Mass Transfer
, Vol. 38
, pp. 519
–531
.7.
Petrescu
S.
1994
, “Comments on the Optimal Spacing of Parallel Plates Cooled by Forced Convection
,” Int. J. Heat Mass Transfer
, Vol. 37
, p. 1283
1283
.8.
Zukauskas, A., 1987, “Convective Heat Transfer in Cross Flow,” in: S. Kakac, R. K. Shah, and W. Aung, Handbook of Single-Phase Convective Heat Transfer, Wiley, New York, Chap. 6.
This content is only available via PDF.
Copyright © 1995
by The American Society of Mechanical Engineers
You do not currently have access to this content.
