Aluminum autobody sheets produce appreciable amounts of slivers during trimming operations when trimmed with dies conventionally designed for steel sheets. The slivers can be carried through downstream processes and cause damage to the surface of formed parts resulting in costly manual repair. This paper reports a systematic experimental study at both the macro- and micro-scale of the sliver generation problem with relation to cutting angle, clearance, and blade sharpness. It is concluded that slivers can be reduced or even eliminated by modifying the current trimming tools designed for steel sheets. The most striking finding is that the conventional wisdom of 0-degree cutting conditions generate the largest amount of slivers for aluminum alloy sheets. With proper cutting angles, trimming aluminum autobody sheets can actually be more robust than that for steel sheets—the clearances can be less restrictive and tools may require much less frequent sharpening. The microscopic investigation traced the origins of slivers and revealed the mechanisms of sliver generation. The paper demonstrates that the integration of material microstructure and mechanics is very beneficial for solving a significant manufacturing problem and can greatly improve the process of shearing aluminum alloy autobody sheet.
Skip Nav Destination
Article navigation
February 2003
Technical Papers
Sliver Generation Reduction in Trimming of Aluminum Autobody Sheet
Ming Li, Mem. ASME
Ming Li, Mem. ASME
Alcoa Technical Center, Alcoa, Inc., Alcoa Center, PA 15069
Search for other works by this author on:
Ming Li, Mem. ASME
Alcoa Technical Center, Alcoa, Inc., Alcoa Center, PA 15069
Contributed by the Manufacturing Engineering Division for publication in the Journal of Manufacturing Science and Engineering. Manuscript received Feb. 2001; Revised March 2002. Associate Editor: K. Stelson.
J. Manuf. Sci. Eng. Feb 2003, 125(1): 128-137 (10 pages)
Published Online: March 4, 2003
Article history
Received:
February 1, 2001
Revised:
March 1, 2002
Online:
March 4, 2003
Citation
Li, M. (March 4, 2003). "Sliver Generation Reduction in Trimming of Aluminum Autobody Sheet ." ASME. J. Manuf. Sci. Eng. February 2003; 125(1): 128–137. https://doi.org/10.1115/1.1540113
Download citation file:
Get Email Alerts
Cited By
In-Situ Monitoring and Its Correlation to Mechanical Properties in Additively Manufactured 718 Ni Alloy
J. Manuf. Sci. Eng (March 2025)
NoodlePrint: Cooperative Multi-Robot Additive Manufacturing With Helically Interlocked Tiles
J. Manuf. Sci. Eng (June 2025)
Related Articles
Drilling Characteristics of an E-Glass Fabric-Reinforced Polypropylene Composite and an Aluminum Alloy: A Comparative Study
J. Manuf. Sci. Eng (December,2007)
Microcutting and Forming of Thin Aluminium Foils for MEMS
J. Manuf. Sci. Eng (December,2011)
An Exit Burr Model for Drilling of Metals
J. Manuf. Sci. Eng (November,2001)
Edge Trimming of Aluminum Sheets Using Shear Slitting at a Rake Angle
J. Manuf. Sci. Eng (November,2006)
Related Proceedings Papers
Related Chapters
Cut Edge Behavior
New Advanced High Strength Steels: Optimizing Properties
Classification of Part Shaping Methods
Introduction to Plastics Engineering
Section III: Subsections NC and ND—Class 2 and 3 Components
Companion Guide to the ASME Boiler & Pressure Vessel Codes, Volume 1 Sixth Edition