Local hot spots can occur in some pressure vessels and piping systems used in industrial processes. The hot spots could be a result of, for instance, localized loss of refractory lining on the inside of pressure components or due to a maldistribution of process flow within vessels containing catalysts. The consequences of these hot spots on the structural integrity of pressure components are of considerable importance to plant operators. The paper addresses structural integrity issues in the context of codes and standards design framework. Interaction of hot spots, as is the case when multiple hot spots occur, is addressed. An assessment method, suitable for further development of a Level 2 “Fitness-for-Service” methodology, is discussed and applied to a commonly used pressure component configuration.

Issue Section:
Research Papers
Keywords:
pressure vessels, refractories, pipes, thermoelasticity
Topics:
Design, Pipes, Pressure, Pressure vessels, Shells, Stress, Temperature, Thermoelasticity, Vessels, Fitness-for-service, Catalysts, Engineering standards, Flow (Dynamics), Linings (Textiles), Piping systems
1.
API, Fitness-For-Service, API 579, American Petroleum Institute, Washington, D.C., 2000.
2.
R5, Assessment Procedure for High Temperature Response of Structures, Nuclear Electric, Berkeley, U.K., 1995.
3.
R6, Assessing the Integrity of Structures Containing Defects, Nuclear Electric, Berkeley, U.K., 1995.
4.
Kraus, H., Thin Elastic Shells (Wiley, New York, 1967).
5.
Lukasiewicz, S., Local Loads in Plates and Shells (Sijthoff and Noordhoff, and PWN-Polish Scientific Publishers, Warszawa, Poland, 1979).
6.
Flugge, W., Stresses in Shells (Springer-Verlag, Berlin, 1973).
7.
Mokhtarian, K., 1968, “Hot Spot Flexure of Plate on Circular Support,” Proceedings of the ASCE, Journal of the Engineering Mechanics Division, Vol. 94, No. EM3, Paper No. 6010, pp. 873–890.
8.
Mura, T., and Koya, T., Variational Methods in Mechanics (Oxford University Press, New York, 1992).
9.
Pan, L., and Seshadri, R., 2001, “Limit Load Estimation Using Plastic Flow Parameter in Repeated Elastic Finite Element Analysis,” ASME PVP-Vol. 43, pp. 145–150.
10.
Bednar, H. H., Pressure Vessel Design Handbook (Van Nostrand Reinhold, New York, 1986).
11.
ANSYS, Educational Version, 6.0, SAS IP, Inc., 2000.
Copyright © 2005
 by ASME
You do not currently have access to this content.