An aluminum roll-bond panel with a photovoltaic module on the surface was developed recently for use as an evaporator of a heat pump for residential hot water supply and room heating [Proceedings of the JSES/JWEA Joint Conference, Okinawa, pp. 305–308 (in Japanese)]. In the present study, the panel was modified to reduce the large pressure loss of the refrigerant flow at the evaporator. Total area of the panels was $1.9m2$ and the rated capacity of the compressor was 250 W. A collector efficiency factor of 0.9 was obtained for the evaporator. The effect of the location of the feeler bulb on performance of the heat pump was also examined.

1.
Fujita, M., Takushima, A., Nakahara, Y., and Ito, S., 1998, “Studies of a System for Electric Power Generation, Air Conditioning and Hot Water Supply Using Photovoltaic and Thermal Hybrid Panels—Heat Pump System and the Results of Operations in the Summer Time,” Proc. JSES/JWEA Joint Conference, Okinawa, pp. 305–308 (in Japanese).
2.
Kanou, M., Murata, T., and Nakahara, Y., 1999, “Evaluation Test of Photovoltaic-Thermal Hybrid System for Residential Building in Summer Time,” Proceedings of the JSES/JWEA Joint Conference, Ooita, pp. 333–336 (in Japanese).
3.
Charter, W. W. S., and Taylor, L. E., 1976, “Some Performance Characteristics of a Solar Boosted Heat Pump,” Proceedings of the I. I. R. Conference, Melbourne, Australia, pp. 641–648.
4.
Chaturvedi
,
S. K.
,
Chiang
,
Y. F.
, and
Roberts
, Jr.,
A. S.
,
1982
, “
Analysis of Two-Phase Flow Solar Collectors With Application to Heat Pumps
,”
J. Sol. Energy Eng.
,
104
, pp.
358
365
.
5.
Sigma Research, Inc.
,
1982
, “
Direct Expansion Solar Collector and Heat Pump
,”
U.S. DOE Rep (USA)
[DOE-SF-10542-T1].
6.
O’Del
,
M. P.
,
Michel
,
J. W.
, and
Beckma
,
W. A.
,
1984
, “
Design Method and Performance of Heat Pumps with Refrigerant-filled Solar Collectors
,”
J. Sol. Energy Eng.
,
106
, pp.
159
164
.
7.
Krakow
,
K. I.
, and
Lin
,
S.
,
1984
, “
Seasonal Performance of Multiple-Source Heating in Cold Climates
,”
ASHRAE Trans.
,
90
, pp.
137
151
.
8.
Hino
,
T.
,
1998
, “
Performance Prediction of an Ambient Energy Heat Pump Based on Sol-Air Temperature
,”
J. Archit. Plan. Environ. Eng., AIJ
, No.
503
, pp.
53
60
.
9.
Ito
,
S.
,
Miura
,
N.
,
Wang
,
J. Q.
, and
Nishikawa
,
M.
,
1997
, “
Heat Pump Using a Solar Collector with Photovoltaic Modules on the Surface
,”
ASME J. Sol. Energy Eng.
,
119
, pp.
1
5
.
10.
Fujita, M., and Ito, S., 1995, “Heat Pump Using Evaporator with Photovoltaic Modules (Influence of Weather Conditions and Condensation Temperature on the Performance),” Proceedings of the Symposium on Environmental Engineering, Yokohama, pp. 353–356 (in Japanese).
11.
Ito
,
S.
,
Miur
,
N.
, and
Wang
,
K.
,
1999
, “
Performance of a Heat Pump Using Direct Expansion Solar Collectors
,”
Sol. Energy
,
65
, pp.
189
196
.
You do not currently have access to this content.