The burnishing wear of carbon films found in dynamic microdevices could be attributed to both mechanical stress and temperature rise by frictional heat generation. In this study, novel modeling and experiment were performed to investigate the burnishing wear mechanism of carbon film during high speed sliding contact. An improved thermomechanical contact model for a single asperity was extended to rough surface contact. The contact stress and surface temperature rise were examined at various contact conditions. To verify the thermal degradation of the carbon film by frictional heat flux, micro-Raman spectroscopy measurement was performed on actual burnishing failure sample.
Issue Section:
Friction & Wear
References
1.
2.
Mate
, C. M.
, 2008
, Tribology on the Small Scale; A Bottom up Approach to Friction, Lubrication and Wear
, Oxford University Press
, New York
.3.
Merlijn van Spengen
, W.
, 2003
, “MEMS Reliability From a Failure Mechanisms Perspective
,” Microelectron. Reliab.
, 43
(7
), pp. 1049
–1060
.10.1016/S0026-2714(03)00119-74.
Hogmark
, S.
, Jacobson
, S.
, and Larsson
, M.
, 2000
, “Design and Evaluation of Tribological Coatings
,” Wear
, 246
(1–2
), pp. 20
–33
.10.1016/S0043-1648(00)00505-65.
Martini
, C.
, and Ceschini
, L.
, 2011
, “A Comparative Study of the Tribological Behavior of PVD Coatings on the Ti-6Al-4V Alloy
,” Tribol. Int.
, 44
(3
), pp. 297
–308
.10.1016/j.triboint.2010.10.0316.
Haque
, T.
, Morina
, A.
, and Neville
, A.
, 2010
, “Influence of Friction Modifier and Antiwear Additives on the Tribological Performance of a Non-Hydrogenated DLC Coating
,” Surf. Coat. Technol.
, 204
(24
), pp. 4001
–4011
.10.1016/j.surfcoat.2010.05.0177.
Sebastiani
, M.
, Eberl
, C.
, Bemporad
, E.
, and Pharr
, G. M.
, 2011
, “Depth-Resolved Residual Stress Analysis of Thin Coatings by a New FIB-DIC Method
,” Mater. Sci. Eng., A
, 528
(27
), pp. 7901
–7908
.10.1016/j.msea.2011.07.0018.
Sheeja
, D.
, Tay
, B. K.
, Lau
, S. P.
, and Shi
, X.
, 2001
, “Tribological Properties and Adhesive Strength of DLC Coatings Prepared Under Different Substrate Bias Voltages
,” Wear
, 249
(5–6
), pp. 433
–439
.10.1016/S0043-1648(01)00541-59.
Fu
, Y.
, Du
, H.
, and Sun
, C. Q.
, 2003
, “Interfacial Structure, Residual Stress and Adhesion of Diamond Coatings Deposited on Titanium
,” Thin Solid Films
, 424
(1
), pp. 107
–114
.10.1016/S0040-6090(02)00908-210.
Holmberg
, K.
, Ronkainen
, H.
, and Matthews
, A.
, 2000
, “Tribology of Thin Coatings
,” Ceram. Int.
, 26
(7
), pp. 787
–795
.10.1016/S0272-8842(00)00015-811.
Holmberg
, K.
, Matthews
, A.
, and Ronkainen
, H.
, 1998
, “Coatings Tribology-Contact Mechanism and Surface Design
,” Tribol. Int.
, 31
(1–3
), pp. 107
–120
.10.1016/S0301-679X(98)00013-912.
Tillmann
, W.
, Sprute
, T.
, Hoffmann
, F.
, Chang
, Y.
, and Tsai
, C.
, 2013
, “Influence of Bias Voltage on Residual Stresses and Tribological Properties of TiAlVN-Coatings at Elevated Temperatures
,” Surf. Coat. Technol.
, 231
, pp. 122
–125
.10.1016/j.surfcoat.2012.03.01213.
Tallant
, D. R.
, Parmeter
, J. E.
, Siegal
, M. P.
, and Simpson
, R. L.
, 1995
, “The Thermal Stability of Diamond-Like Carbon
,” Diamond Relat. Mater.
, 4
(3
), pp. 191
–199
.10.1016/0925-9635(94)00243-614.
Inoube
, A.
, Shen
, B.
, Koshiba
, H.
, Kato
, H.
, and Yacari
, A. R.
, 2003
, “Cobalt-Based Bulk Glassy Alloy With Ultrahigh Strength and Soft Magnetic Properties
,” Nature Mater.
, 2
, pp. 661
–663
.10.1038/nmat98215.
Shamsa
, M.
, Liu
, W. L.
, and Balandin
, A. A.
, 2006
, “Thermal Conductivity of Diamond-Like Carbon Films
,” Appl. Phys. Lett.
, 89
(16
), p. 161921
.10.1063/1.236260116.
Lee
, S.
, and Yeo
, C.-D.
, 2012
, “Microwear Mechanism of Head Carbon Film During Head Disk Interface Sliding Contact
,” Tribol. Int.
, 45
(1
), pp. 30
–37
.10.1016/j.triboint.2011.09.00717.
Yeo
, C.-D.
, Katta
, R. R.
, and Polycarpou
, A. A.
, 2009
, “Improved Elastic Contact Model Accounting for Asperity and Bulk Substrate Deformation
,” Tribol. Lett.
, 35
(3
), pp. 191
–203
.10.1007/s11249-009-9448-018.
Johnson
, K. L.
, 1985
, Contact Mechanics
, Cambridge University Press
, Cambridge, UK
, pp. 90
–104
.19.
Yeo
, C.-D.
, Katta
, R. R.
, and Polycarpou
, A. A.
, 2010
, “Effect of Asperity Interactions on Rough Surface Elastic Contact Behavior: Hard Film on Soft Substrate
,” Tribol. Int.
, 43
(8
), pp. 1438
–1448
.10.1016/j.triboint.2010.01.02120.
Jaeger
, J. C.
, 1943
, “Moving Sources of Heat and the Temperature at Siding Contacts
,” J. Proc. R. Soc. New South Wales
, 76
, pp. 203
–224
.21.
Francis
, H. A.
, 1970
, “Interfacial Temperature Distribution Within a Sliding Hertzian Contact
,” Tribol. Trans.
, 14
(1
), pp. 41
–54
.10.1080/0569819710898322622.
Özisik
, M. N.
, 1993
, Heat Conduction
, 2nd ed., Wiley-Interscience Publication
, New York
, pp. 325
–339
.23.
Ravichandran
, K.
, An
, K.
, Dutton
, R. E.
, and Semiatin
, S. L.
, 1999
, “Thermal Conductivity of Plasma-Sprayed Monolithic and Multilayer Coatings of Alumna and Yttria-Stabilized Zirconia
,” J. Am. Ceram. Soc.
, 82
(3
), pp. 673
–682
.10.1111/j.1151-2916.1999.tb01816.x24.
Lee
, C. K.
, 2011
, “Effects of Multiple Ground Layers on Thermal Response Test Analysis and Ground-Source Heat Pump Simulation
,” Appl. Energy
, 88
(12
), pp. 4405
–4410
.10.1016/j.apenergy.2011.05.02325.
Mills
, A. F.
, 1999
, Basic Heat Mass Transfer
, 2nd ed., Prentice Hall
, Upper Saddle River, NJ
, Chap. 3.26.
Lee
, S.
, Yeo
, C.-D.
, Purani
, D.
, and Kim
, A. S.
, 2013
, “Thermomechanical Contact Between Magnetic Recording Head and Disk Defect Accounting for Heat Partition Factor
,” IEEE Trans. Magn.
, 50
(33
), p. 3300307
.10.1109/TMAG.2013.228535127.
Gong.
, Z.-Q.
, and Komvopoulos
, K.
, 2004
, “Mechanical and Thermomechanical Elastic-Plastic Contact Analysis of Layered Media With Patterned Surfaces
,” ASME J. Tribol.
, 126
(1
), pp. 9
–17
.10.1115/1.160948728.
Lee
, K. M.
, Yeo
, C.-D.
, and Polycarpou
, A. A.
, 2006
, “Mechanical Property Measurements of Thin Film Carbon Overcoat on Recording Media Towards 1 Tb/in2
,” J. Appl. Phys.
, 99
(8
), p. 08G906
.10.1063/1.216659529.
Yeo
, C.-D.
, Polycarpou
, A. A.
, Kiely
, J. D.
, and Hsia
, Y.-T.
, 2007
, “Nanomechanical Properties of Ultra-thin Carbon Film Overcoats Using the Nanoindentation Technique
,” J. Mater. Res.
, 22
, pp. 141
–151
.10.1557/jmr.2007.000730.
Yu
, N.
, Polycarpou
, A. A.
, and Hanchi
, J. V.
, 2010
, “Thermomechanical Finite Element Analysis of Slider-Disk Impact in Magnetic Storage Thin Film Disks
,” Tribol. Int.
, 43
(4
), pp. 737
–745
.10.1016/j.triboint.2009.10.01431.
Bhuhshan
, B.
, 1995
, Handbook of Micro/Nanotribology
, CRC Press
, Boca Raton, FL
.32.
Mutsukura
, N.
, Tomita
, S.
, and Mizuma
, Y.
, 1992
, “The Mechanical Properties of Hydrogenated Hard Carbon Films
,” Thin Solid Films
, 214
(1
), pp. 58
–62
.10.1016/0040-6090(92)90455-K33.
Li
, N.
, Zheng
, L.
, Meng
, Y.
, and Bogy
, D. B.
, 2009
, “Experimental Study of Head-Disk Interface Flyability and Durability at Sub-1-nm Clearance
,” IEEE Trans. Magn.
, 45
(10
), pp. 3624
–3627
.10.1109/TMAG.2009.202400234.
Lewis
, I. R.
, and Edwards
, H.
, 2001
, Handbook of Raman Spectroscopy
, 2nd ed., CRC Press
, Boca Raton, FL
, Chap. 24.35.
Ferrari
, A. C.
, 2004
, “Diamond-Like Carbon for Magnetic Storage Disks
,” Surf. Coat. Technol.
, 180–181
, pp. 190
–206
.10.1016/j.surfcoat.2003.10.146Copyright © 2014 by ASME
You do not currently have access to this content.
