... and subsurface layers. This work addresses the influence of selected deep rolling parameters (pressure, speed, feed, and number of passes) on the surface integrity (roughness, surface and subsurface microhardness, and microstructure) of AISI 1020, AISI 1065, and AISI 1080 carbon steels. Deep rolling...

... of erosion wear rate for the present experimental data. 11 07 2010 06 06 2011 25 07 2011 25 07 2011 aluminium alloys brass carbon steel copper cutting deformation ductility hardness particle size slurries stainless steel wear wear testing cutting wear maximum...

...-on-disk test, which can measure the friction and the removal rate in magnetic field, is conducted to detect the lubricating effects of MR fluid when the magnetic field is applied. In order to obtain the practical meaning of the study, the material of the specimen is chosen to be SM45C carbon steel...

... adhesion carbon steel deep drawing galvanising high-pressure effects lubrication mechanical contact sliding friction 22 03 2010 18 11 2010 21 12 2010 21 12 2010 2011 American Society of Mechanical Engineers ...

...A. Abouel-Kasem; B. Saleh; S. M. Ahmed Wear particles produced by vibratory cavitation erosion tests on 1017 carbon steels in water and oil-in-water (o∕w) emulsions were analyzed. Scanning electron microscope (SEM) images of wear particles were acquired, forming a database for further analysis...

...Niyazi Ozdemir; Furkan Sarsilmaz; Nuri Orhan In this study, the abrasive wear behavior of a grain refined hypereutectoid carbon steel containing 1.2% C, 4% Al, 0.20% Mo, and 0.1% Ti was investigated experimentally. Thermal cycles were applied to all specimens about ten times to obtain a fine...

... on the tribological behavior of 1080 carbon steel were investigated. Laser glazing is a process in which a high-power laser beam melts the top layer of the surface, followed by rapid cooling and resolidification. This results in a new surface layer microstructure and properties. Laser shock peening, on the other hand...

...A. Shirizly; J. G. Lenard Low carbon steel strips were cold rolled using various lubricants. The objectives were twofold. The first concerned whether the use of an emulsion would lower the loads on the mill as much as a neat oil would. The second was to study the effect of the lubricant...