The behavior of vaned radial diffusers is generally considered to be due to the flow phenomena in the vaneless and the semi-vaned space in the diffuser inlet region. Even considering unsteady aspects, the adjacent diffuser channel is regarded as less important. The flat wedge vaned diffuser of the centrifugal compressor stage investigated allows an independent continuous adjustment of the diffuser vane angle and the radial gap between impeller outlet and diffuser vane inlet, so that information about the importance of these geometric parameters can be obtained. The time-dependent pressure distribution on the diffuser front wall and on the suction and pressure surfaces of the diffuser vanes reveal that in the semi-vaned space mainly the region near the vane suction side is influenced by the unsteady impeller-diffuser interaction. Downstream in the diffuser channel the unsteadiness does not decay. Here, pressure fluctuations are appearing that are distinctly higher than the pressure fluctuations in the vaneless space. An estimation of the influence of the unsteadiness on the operating performance of the centrifugal compressor stage is made by measurements at choke and surge limit for different diffuser geometries.

Issue Section:
Research Papers
Topics:
Compressors, Diffusers, Geometry, Unsteady flow, Pressure, Fluctuations (Physics), Impellers, Suction, Flow (Dynamics), Surges, Wedges
1.
Arndt
N.
,
Acosta
A. J.
,
Brennen
C. E.
, and
Caughey
T. K.
,
1990
, “
Experimental Investigation of Rotor-Stator Interaction in a Centrifugal Pump With Several Vaned Diffusers
,”
ASME JOURNAL OF TURBOMACHINERY
, Vol.
112
, pp.
98
–
108
.
2.
Bo¨lcs, A., and Suter, P., 1986, Transsonische Turbomaschinen, Verlag G. Braun, Karlsruhe.
3.
Dean, R., and Senoo, Y., 1960, “Rotating Wakes in Vaneless Diffusers,” ASME Journal of Basic Engineering, Vol. 82.
4.
Eckardt, D., 1973, “Untersuchung der Strahl-/Totwasserstro¨mung hinter einem hochbelasteten Radialverdichterlaufrad,” Diss. RWTH Aachen.
5.
Eckardt, D., 1975, “Instantaneous Measurements in the Jet and Wake Discharge Flow of a Centrifugal Impeller,” ASME Journal of Engineering for Power, Vol. 97.
6.
Elder
R. L.
, and
Gill
M. E.
,
1985
, “
A Discussion of the Factors Affecting Surge in Centrifugal Compressors
,”
ASME Journal of Engineering for Gas Turbines and Power
, Vol.
107
, pp.
499
–
506
.
7.
Fisher, E., and Inoue, M., 1981, “A Study of Diffuser/Rotor Interaction in a Centrifugal Compressor,” Journal of Mechanical Engineers, Vol. 23, No. 3.
8.
Haß, U., and Rautenberg, M., 1977, “Zum Einfluß des Mischungsprozesses und der Reibung nach dem Laufrad eines hochbelasteten Radialverdichters auf den statischen und totalen Druckverlauf,” Konstruktion 29.
9.
Jansen, W., Carter, A., and Swarden, M., 1980, “Improvements in Surge Margin for Centrifugal Compressors,” AGARD Conference Proceedings No. 282-19.
10.
Japikse, D., 1987, “The Technology of Centrifugal Compressors: A Design Approach and New Goals for Research,” VKI Lecture Series 1987-01.
11.
Johnston, J., and Dean, R., 1966, “Losses in Vaneless Diffusers of Centrifugal Compressors and Pumps,” ASME Journal of Engineering for Power, Vol. 82.
12.
Justen, F., 1993, “Experimentelle Untersuchung instationa¨rer Stro¨mungsvorga¨nge im beschaufelten Diffusor variabler Geometrie einer hochbelasteten Radialverdichterstufe,” Diss. RWTH Aachen.
13.
Kline, S., Abbot, D., and Fox, R., 1959, “Optimum Design of Straight-Walled Diffusers,” ASME Journal of Basic Engineering, Vol. 81.
14.
Kosuge, H., Ito, T., and Nakanishi, K., 1982, “A Consideration Concerning Stall and Surge Limitations Within Centrifugal Compressors,” ASME Journal of Engineering for Power, Vol. 104, No. 4.
15.
Krain, H., 1980, “Experimental and Theoretical Investigations on the Internal Flow in a Centrifugal Compressor,” AGARD Conference Proc. No. 282-1.
16.
Krain, H., 1981, “A Study on Centrifugal Impeller and Diffuser Flow,” ASME Journal of Engineering for Power, Vol. 103.
17.
Krain, H., Hoffmann, B., and Pak, H., 1995, “Aerodynamics of a Centrifugal Compressor Impeller with Transonic Inlet Conditions,” ASME Paper No. 95-GT-79.
18.
Rhone, K., and Baumann, K., 1988, “Untersuchungen der Stro¨mung am Austritt eines offenen Radialverdichterlaufrades und Vergleich mit der klassischen Jet-Wake Theorie,” VDI Berichte No. 706.
19.
Rothstein, M., 1993, “Entwicklung und experimentelle Untersuchung eines Radialverdichters mit beschaufeltem Diffusor variabler Geometrie,” Diss. RWTH Aachen.
20.
Runstadler, P., Dolan, F., and Dean, R., 1975, “Diffuser Data Book,” CREARE Technical Note 186.
21.
Senoo, Y., and Ishida, M., 1975, “Behavior of Several Asymmetric Flow in a Vaneless Diffuser,” ASME Journal of Engineering for Power, Vol. 97.
This content is only available via PDF.
Copyright © 1999
 by The American Society of Mechanical Engineers
You do not currently have access to this content.